User guide

3.0 ENCLOSURE INSTALLATION

The DS7060 control/communicator and the enclosure are shipped to-

gether. The control, however, still needs to be installed into the enclo-

sure. Hardware for mounting the enclosure to a wall, and the control to

the enclosure is located in its own hardware pack.

3.1 Install the Enclosure

NOTE: This panel is intended for mounting in a restricted access area

and should be wall mounted.

CAUTION: The control panel should only be installed by authorized

service personnel.

• Use the enclosure as a template and mark the mounting holes on the

mounting surface.

• Pre-start the mounting screws for these holes. Mount the enclosure.

• Knock out the desired wire entrances on the enclosure.

3.2 Install the Control/Communicator

CAUTION: The control is static sensitive. Make sure you touch

earth ground before handling the control. This will

discharge any static electricity in your body.

EXAMPLE: Run the ground wire to the enclosure before handling

the control. Then, holding the ground wire (or using a

ground strap), install the control.

• Insert the two support posts into the control retainer holes as

shown below in the Support Post Assembly diagram.

• Slide the top of the control PCB into the two retainer tabs.

• Once in the retainer tabs, the control will rest on the two support

posts.

• Secure the bottom of the enclosure by screwing the bottom two

holes through the support posts and through to the control re-

tainer holes.

CAUTION: Once the control is installed, be sure to connect its

ground wire to the top hinge of the enclosure.