User guide

7.26 Address 32 - Battery, AC Report

• Low Battery Report: This report is sent when a low battery condition occurs.

• Low Battery Restoral Report: This report is sent when a low battery condition restores.

• AC Failure Report: This report is sent after an AC failure condition occurs. AC failure reports will only be sent along with other re-

ports if Address 50 is set to “000.” Otherwise reports will be sent after the delay set in Address 50.

• AC Failure Restoral Report: This report is only sent along with other reports if Address 50 is set to “000.” Otherwise reports will be

sent after the delay set in Address 50.

7.27 Address 33 - Programming Report

• Remote Programming Successful: This report is sent after a Remote Programming session, if the session was terminated properly.

• Remote Programming Unsuccessful: This report is sent after a Remote Programming session, if some error has occurred or the

session did not terminate properly.

• Local Programming Successful: This report is sent when local programmer’s mode is exited and there has been no error associated

with the programming.

7.28 Address 34 - System Report

• System Trouble: This report is sent when a control trouble condition occurs.

• System Trouble Restoral: This report is sent when all system trouble conditions restore.