Specifications

ManualsBrandsDetection Systems ManualsHome building and DecorDS7060

General System Problems (Continued)

Symptom Probable Cause Possible Solution

#87 display = RAM Fault

#89 display = System Fault 01

#87 display = ROM Fault

#89 display = System Fault 02

#87 display = EEProm Fault #89 dis-

play = System Fault 03

#87 display = Communicator Err

#89 display = Report Failure X

#87 display = 2Ph/Bell Fault #89

display = System Fault 10

#87 display = Line 1 Fault #89

display = System Fault 11

#87 display = Line 2 Fault #89

display = System Fault 12

#87 display = Bell Fault

#89 display = System Fault 13

#87 display = Aux. Output Fault

#89 display = System Fault 14

#87 display = Aux Power Fault

#87 display = Keypad Fault

The control has failed to communicate.

a) The dual phone line/bell supervision

module (DS7420i) is defective or the

wiring to the module is defective.

b) There is no DS7420i or a DS7420i has

been removed from the system.

There is a phone line fault on line 1.

There is a phone line fault on line 2.

The bell circuit on the DS7420i is open or

shorted.

The auxiliary circuit on the DS7420i is open

or shorted.

The auxiliary power output has been short-

ed.

a) The keypad wiring is defective.

b) A keypad is missing.

c) A keypad has been programmed, but is

not intended in this system.

a) An EEProm fault can be caused by disconnecting

power from the control while it is in program mode.

In this case, enter then exit program mode to clear.

b) Try to clear the error at the keypad by entering a

PIN then Reset.

c) Remove AC and battery power, then re-apply.

Remember that event history will be lost and time/

date will have to be re-set.

d) If error persists, return the panel to factory default

programming by setting program address 4058

to “01”. If the error clears, re-program the panel.

e) If error still persists, replace the panel.

Check history #89 to determine the source:

Report Failure 1 = Phone number 1

Report Failure 2 = Phone number 2

Report Failure 3 = Phone number 3 (remote

programmer)

Report Failure 4 = ARDIS Network

a) Check the wiring to the module.

b) Enter, then exit programming mode. This will re-

scan the options bus and clear the problem.

Check phone line 1 for proper operation.

Check phone line 2 for proper operation. If you wish

to monitor only one phone line, reprogram address

1520.

Check the bell circuit wiring. Be sure that the end-of-

line resistor is in place. If you don’t wish to use the

bell circuit, place an end-of-line resistor across the

bell terminals.

Check the auxiliary circuit wiring. Be sure that the

end-of-line resistor is in place. If you don’t wish to

use the auxiliary circuit, place an end-of-line resistor

across the auxiliary terminals. If you wish to use the

auxiliary circuit but do not wish to supervise it, cut

the auxiliary supervision jumper on the DS7420i.

Remove wiring from auxiliary power and check for

shorts.

a) Check keypad operation and wiring.

b) Install a keypad.

c) Remove from programming (0173-0180).