Specifications

9.3 Disarming from the Master Keypad

Disarming all the

Partitions you have

access to.

Enter your PIN followed by the [Off] key.

This will disarm all of your partitions, even if some are already disarmed.

Disarming from the Master Keypad

Disarming only some

of your Partitions

You must enter Single Partition Mode to disarm the necessary partitions one at a time.

1. Enter your PIN, followed by the [#] key twice: [1] [2] [3] [4] [#] [#].

2. The first partition you have access to will be displayed: “Armed. Cafeteria.”

3. Complete the disarming command sequence for this partition: [Off].

4. Move to the next partition you have access to by pressing the [#] key twice: [#] [#].

5. The next partition you have access to will be displayed: “Armed. Office.”

6. Complete the disarming command sequence for this partition.

7. After you have disarmed all the partitions you have access to, exit Single Partition

Mode by pressing the [*] key for 2 seconds.

9.4 Single Partition Mode

Single Partition Mode is used to control partitions on a “one at a time/one by one” basis from the Master keypad.

To enter the Single Partition Mode, enter your PIN, then press the [#] key twice. This will call up the first partition you have access to. Enter

the command sequence you wish for this partition. You do not need to use your PIN again. To move on to the next partition you have

access to, press the [#] key twice.

To exit the Single Partition Mode, hold the [*] key down for 2 seconds. The system will automatically drop out of Single Partition Mode after

40 seconds without a keypad entry.

10.0 How to Program the Control Panel

10.1 Entering the Programmer’s Mode

To enter the Programmer’s Mode, enter the Programmer’s Code followed by [#] [0]. Shorting the program pads (see section 2.0 for

location) on the control panel will also activate Programmer’s Mode.

The default Programmer’s Code is [9] [8] [7] [6].

10.2 Reading back a Program Address

Once you are in the programmer’s mode, to read back the value of a Program Address, enter that Program Address followed by [#]. Each

data digit is displayed one data digit at a time. To view the second data digit, enter the # button again.

The display will look like this:

10.3 Entering a value in a Program Address

To enter a value in the Program Address, enter the Program Address, then enter the value for each Data Digit, then enter [#] to save it and

move on to the next Program Address. Entering data digit 1 will increment you to the next data digit.

The display will show the Program Address and will display the value of each Data Digit after you enter it. The data will be programmed

(saved) when you press the [#] key. The control panel will automatically increment to the next program address.

• If you wish to program that next address, enter the necessary information.

This is the program address

Prog. Mode 3.00

Adr.= 0000 D01= 2

This is the data digit number

This is the value of this

data digit