Specifications

DS7400Xi Ver. 3+ Reference Guide Copyright © 1995-96 Detection Systems, Inc. Page 24
8.7 Automatic Arming
Each partition can be programmed to automatically arm once per day.
To inform occupants that the system is about to arm, a pre-arming period will begin 15 minutes before the system arms automatically. The
keypad sounders, and any outputs programmed to follow the keypad sounders, will pulse five times every minute. During the last five
minutes before arming, these sounders will be on steady. Once per minute the keypad will read, “Arm in nn min./PIN + OFF - extend.”
If automatic arming is used in Master Keypad mode, it will affect all partitions you have access to. If used in single partition mode, or from
a single partition keypad, it will affect only the partition you are working in.
To extend the Automatic Arming of the system during the automatic arming pre-arming period 15 minutes, enter a valid user code plus OFF
[PIN] + [OFF]. For a longer delay, perform the following steps:
NotesDelayed Automatic Arming
Enter a PIN
Enter [9] [9]
to enter the Delayed Arming programming
Enter the number of hours from now
that you would like the system to arm.
For example: If if is 3:30 now, and you
would like the system to arm at 9:30,
enter 06.
The keypad will display the following:
Arm in nn Hours
# to accept
* = To extend the Automatic Arming at any time, use the Delayed Arming feature (see section 8.6).
To program the Automatic Arming Time, perform the following steps:
NotesSetting the Automatic Arming Time
Enter a Master PIN + [#] + [0]
Setting the Automatic Arming Time can only be
performed in the Master Programming Mode.
Enter a [1]
to enter the Automatic Arm Setup programming
Enter the partition number.
Press [#] to exit.
If programming is done from a Master Keypad
that is not in single partition mode, the user will
be prompted to enter the partition they wish to
program.
The user will only be allowed to program the
partitions to which they are assigned. If pro-
gramming from a standard keypad, or from a
Master Keypad in single partition mode, this
step will be skipped.
Enter a time for each day.
Enter in [0] [1] [0] [0] [#] format.
The display will start with Sunday. It will read,
“Sunday - nn : nn”
Enter the time in 24 hour format then press the
[#] key. If you make a mistake, press the [*] key
twice to move back to your last entry.
Samples of times:
12 noon = 1200#
12:01am = 0001#
1:00am = 0100#
Disabled = 0000#
12 midnight = 2400#
12:01pm = 1201#
1:00pm = 1300#