User's Manual

6
 Check all the wired connections
 Reboot the device by simultaneously holding the open and close buttons
Smart Base Station V2
The Smart Base Station connects to the internet and receives all messages from Sensors,
Valve Controllers and Hubs and translates that information into a user interface.
Device States:
Status
Lights
Beeper
Boot
Blue Yellow Red
1 beep
Active
1x Blue every 15s
External DC Alarm
Solid Yellow
Battery Alarm/Disconnected
1x Yellow every 5s, 1x Red
Critical Battery
Not Communicating
Solid Red
On Communication Failover
1x Yellow every 15s
Check Status Press S3
---
4 Beeps
Device Operation:
 Installation:
o Connect power and Ethernet to the Smart Base Station
o Refer to login information to access the user interface to complete
configuration
 Boot:
o Connect external power, press s1
 Active Mode:
o Led blink to show status
 Troubleshooting:
o External DC Alarm:
 Check power connections at the device and at the wall
 Check the wall outlet to ensure it is active
o Battery Alarm/Disconnected
 Check power connections at the device and at the wall
 Check the wall outlet to ensure it is active
o Not Communicating/Communication Failover
 Check physical connections
 Refer to user interface for further instruction