User's Manual

4
 Check that nearby Hubs and Smart Base Station are properly configured
 Adjust the location of the Sensor
Valve Controller(s)
Valve Controllers are installed strategically near points where valves need to be controlled and/or
monitoring is necessary from the connected sensing device(s).
Device States:
Status
Lights
Sound
Boot
Blue Yellow Red
1 beep
Connecting
1x Yellow every 15s
Good Setup
3x Blue
1 beep
Failed Setup
3x Red
3 beeps
Active
1x Blue every 15s
Alarm
1x Red every 3s
1x short every 3s
Not Communicating
1x Red every 15s
Silence
1x Yellow every 15s
Reset
3x Blue
1 beep
Test
1x Yellow every 15s
1 beep
Battery Warning
1x Yellow every 15s
Battery Alarm
1x Red every 15s
External DC Alarm
1x Red every 15s
Valve(s) Failed
Rapid Red
Valve 1 Closed
2nd LED Red
Valve 2 Closed
3rd LED Red
Valve 1 open
2nd LED Blue
Valve 2 Open
3rd LED Blue
Device Operation:
 Installation:
o Determine the location where the Valve Controller will be placed to serve the desired
purpose
o Register the Valve Controller to the Hub and Smart Base Station
 Hold S1 for 10 seconds.
 The Valve Controller will blink yellow every 3 seconds while connecting
 Three blue blinks and one beep confirms that setup was successful
 Three red blinks and three beeps indicates and network issue.
 Connect the desired valve(s) to the Valve Controller
 The device is now registered
 Configure the valves via the User Interface
 Boot/Reboot Device/Register: