User's Manual

3
Reset
3x Blue
1 beep
Battery Warning
1x Yellow every 15s
Battery Alarm
1x Red every 15s
Not Communicating
1x Red every 15s
Test Mode
1x Yellow every 15s
1 beep
Device Operation:
 Installation:
o Determine the location where the Sensor will be placed to serve the desired purpose
o Register the Sensor to the Hub and Smart Base Station
 Hold S1 for 10 seconds.
 The Sensor will blink yellow every 3 seconds while connecting
 Three blue blinks and one beep confirms that setup was successful
 Three red blinks and three beeps indicates and network issue.
 The device is now registered
 Boot/Reboot Device/Register:
o Depress Center Button for 10 seconds. All lights will flash (Blue, Yellow, Red) and
buzzer will beep one time.
o Cycle the power by removing and reinserting the batteries
 Active Mode:
o Device checks for water every 15 seconds at the same time as the LED blink
 Alarm Mode:
o Device blinks red and beeps once every 3 seconds
 Cycle will continue until S1 is pressed
o Details of the alarm are displayed, emailed, texted and phone calls are placed to
appropriate personnel.
 Silence:
o Press S1 to silence the alarm
o Details of the silence are displayed, emailed, and texted to appropriate personnel.
 Reset:
o For the lockout time that is designated in the User Interface, the sensor will be in a
reset mode where it will not detect water.
o Press and hold S1 for 10 seconds to exit reset mode, or wait for the lockout time to
expire
 Test Mode:
o Press and Hold Center button for 20 seconds
o All messages during this time will be recorded as “Test” messages
o Test mode will automatically end after 120 seconds
 Troubleshooting
o Failed Setup
 Retry registration
 Check that nearby Hubs and Smart Base Station are properly configured
 Adjust the location of the Sensor
o Battery Warning/Alarm
 Replace the batteries in the Sensor
o Not Communicating
 Retry registration