User's Manual

2
Device Operation:
 Installation:
o Determine the location where the Hub will be placed to serve the desired group of
sensors
o Register the Hub to the Smart Base Station
 Hold S2 for 10 seconds.
 The Hub will blink yellow every 3 seconds while connecting
 Three blue blinks and one beep confirms that setup was successful
 Three red blinks and three beeps indicates and network issue.
 The device is now ready for sensors to be registered
 Reboot Device:
o Press S1 on bottom of device. All lights will flash (Blue, Yellow, Red) and buzzer will
beep one time.
 Test Mode:
o Hold S2 on bottom of device for 20 seconds
 The Hub will blink yellow every 15 seconds for 120 seconds
 Any messages sent during this time will be recorded as “Test” messages
 Troubleshooting
o Failed Setup
 Reboot Hub
 Check that nearby Hubs and Smart Base Station are properly configured
 Adjust the location of the Hub
o External DC Alarm
 Check power connections at the device and at the wall
 Check the wall outlet to ensure it is active
o Battery Alarm
 Check power connections at the device and at the wall
 Check the wall outlet to ensure it is active
 Check the User Interface online to ensure device battery level is increasing
 Open device to ensure battery is connected
o Not Communicating
 Reboot Hub
 Check that nearby Hubs and Smart Base Station are properly configured
 Adjust the location of the Hub
Sensor(s)
Sensors are installed strategically near points where monitoring is necessary from the connected
sensing device(s).
Device States:
Status
Lights
Sound
Connecting
1x Yellow every 3s
Good Setup
3x Blue
1 beep
Failed Setup
3x Red
3 beeps
Active
1x Blue every 15s
Alarm
1x Red every 3s
1x short every 3s
Silence
1x Yellow every 15s