User's Manual

ManualsBrandsDetection Group ManualsComputers & AccessoriesSmart Base Station

User Manual – Trident™ Wireless Leak Detection System

The Detection Group system has been protecting Class A commercial and multi-family

buildings for over 10 years and is installed in hundreds of properties. The system

wirelessly monitors leak-prone areas 24x7 and immediately notifies you by phone,

text or email of the precise location of a leak.

Patent-pending Trident is the newest sensor system from The Detection Group.

Trident detects and reports water leaks and can shut water off when required. With

an extended communications range based on an RF frequency, Trident can protect

virtually any type or size of building. As a fully wireless system, it can be deployed

anywhere inside a building and is easily installed in existing buildings and in new

construction.

The Trident system is comprised of sensors, hubs and a Smart Base Station (SBS). A

sensor is the end-device that detects water. Sensors communicate information to

hubs, and those in turn communicate with the Smart Base Station. The Smart Base

Station connects to the cloud over a dedicated ISP Ethernet line, and uses an analog

voice line or cell modem for redundant back-up communications.

Hub(s)

Hubs are installed strategically to connect a group of sensors to other Hubs and the Smart

Base Station. This must be installed before the sensors.

Device States:

Status

Lights

Sound

Boot

Blue Yellow Red

1 beep

Connecting

1x Yellow every 3s

None

Good Setup

3x Blue

1 beep

Failed Setup

3x Red

3 beeps

Active

1x Blue every 15s

None

External DC Alarm

1x Yellow every 15s

None

Battery Alarm

1x Red every 15s

None

Not Communicating

1x Red every 15s

None

Summary of content (8 pages)

PAGE 1
User Manual – Trident™ Wireless Leak Detection System The Detection Group system has been protecting Class A commercial and multi-family buildings for over 10 years and is installed in hundreds of properties. The system wirelessly monitors leak-prone areas 24x7 and immediately notifies you by phone, text or email of the precise location of a leak. Patent-pending Trident is the newest sensor system from The Detection Group. Trident detects and reports water leaks and can shut water off when required.
PAGE 2
Device Operation:     Installation: o Determine the location where the Hub will be placed to serve the desired group of sensors o Register the Hub to the Smart Base Station  Hold S2 for 10 seconds.  The Hub will blink yellow every 3 seconds while connecting  Three blue blinks and one beep confirms that setup was successful  Three red blinks and three beeps indicates and network issue.  The device is now ready for sensors to be registered Reboot Device: o Press S1 on bottom of device.
PAGE 3
Reset Battery Warning Battery Alarm Not Communicating Test Mode 3x 1x 1x 1x 1x Blue Yellow every 15s Red every 15s Red every 15s Yellow every 15s 1 beep 1 beep Device Operation:         Installation: o Determine the location where the Sensor will be placed to serve the desired purpose o Register the Sensor to the Hub and Smart Base Station  Hold S1 for 10 seconds.
PAGE 4
  Check that nearby Hubs and Smart Base Station are properly configured Adjust the location of the Sensor Valve Controller(s) Valve Controllers are installed strategically near points where valves need to be controlled and/or monitoring is necessary from the connected sensing device(s).
PAGE 5
Depress Center Button for 10 seconds. All lights will flash (Blue, Yellow, Red) and buzzer will beep one time. o Cycle the power by simultaneously holding the open and close buttons for 10 seconds.
PAGE 6
  Check all the wired connections Reboot the device by simultaneously holding the open and close buttons Smart Base Station V2 The Smart Base Station connects to the internet and receives all messages from Sensors, Valve Controllers and Hubs and translates that information into a user interface.
PAGE 7
FCC COMPLIANCE This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must be at least 20 cm from the user and must not be co-located or operating in conjunction with any other antenna or transmitter. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
PAGE 8
The information in this guide may change without notice. The manufacturer assumes no responsibility for any errors that may appear in this guide. The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by The Detection Group may void the user’s authority to operate the equipment.