Instruction manual

RXT Wireless Configuration Tool
RXT WCT Instruction Manual Rev 0.0 Page 14 of 33
Select All Selects all RXTs in the RXTs in My Network section including those not displayed if
multiple pages are available.
Unselect All Unselects all RXTs in the RXTs in My Network section including those not displayed if
multiple pages are available.
Clear Removes any RXTs that are selected in the RXTs in My Network section.
Up/Down Arrows These are page up and page down functions if multiple pages are available.
All RXTs can be cleared from the list by performing a Select All and then performing a Clear. At any point in
time the list can be refreshed again by performing a Search My Network again. The user can individually
select one or more RXTs using the actual list displayed. Only one group can be selected at a time. So for
example, the user can reboot a single RXT by selecting it in the list and then perform the Reboot RXT(s)
function.
3.5.4 Search Other Networks
The Search Other Networks operation opens a separate screen and is used for finding RXTs on any
combination of RF channels and network IDs. It allows the user to survey what RF Channels are being used
by RXTs and if desired, to select specific ones found and move them to My Network. There are three main
sections on this screen: Search Channels, Operations and RXTs Found. At the bottom of the screen there is a
single status line of any ongoing operations.
Figure 18 Search Other Networks Operational Button
3.5.4.1 Search Channels
The Search Channels section is used to select the channel to be searched when the Search operation is
selected. There are 16 possible search channels available (0–15) and if the All Channels box is selected the
WCT will perform the search on all 16 channels starting at channel 0. The RXT’s Network ID will be ignored
during the search but will be displayed when found along with their Network Address and Channel in the
RXTs Found section. Each search performed will add any found RXTs to the list, never remove them. So if a
search is done on RF Channel 0 and RF Channel 1, the list will contain RXTs for both channels.
Figure 19 Search Channels Section