Instruction manual

RXT Wireless Configuration Tool
RXT WCT Instruction Manual Rev 0.0 Page 13 of 33
The Config Mode operation allows the user to turn ON or OFF the selected RXT’s configuration mode. This
mode must be turned ON in order for the RXT to be configured.
The Configure RXT(s) operation will configure the selected RXTs by loading it with the selected configuration
file.
The Restore NV Defaults operation will restore non-volatile memory with default parameters.
The Clear RXT operation will erase the current configuration of the selected RXTs and should only be
performed by Detcon personnel.
3.5.3 RXTs In My Network
The RXTs In My Network section is populated with RXTs when the Search My Network operation is
performed. It will display the RXTs Network Address, Device Type, RFE Version, RFE Image Version and
Firmware Version as each RXT responds to the search request. These columns can be sorted ascending or
descending by selecting the actual heading at the top of the list. RXT Count gives the current number of RXTs
that were found which is updated as new ones respond.
Figure 16 RXTs In My Network Section
NOTE: Operations such as Search My Network can be cancelled by selecting the Cancel
button when it appears. The Cancel button will only appear if the operation can be cancelled.
For example, if the user knows all the RXTs have already been found and the process has not
completed, the user can cancel the search operation to save time.
Once Search My Network is completed, RXTs found are displayed and the user can now select specific RXTs
to perform operations on. The functions on the bottom of the RXTs in My Network section allow for viewing
and selecting RXTs to perform operations on.
Figure 17 RXT Function Buttons