Instruction manual

RXT Wireless Configuration Tool
RXT WCT Instruction Manual Rev 0.0 Page 11 of 33
NOTE: RXTs that are part of an operational system are in constant communication with the
master RXT. When searching for RXTs on an operational network, the WCT will temporarily
disable sleep for the current network it is searching. The network sleep function is restored
once the WCT has completed searching the network.
Figure 12 shows the Wireless Network screen for the RXT-300 configuration tool after initialization has been
completed. The red status line shows that the search is complete and the RXTs In My Network section shows
the list of RXTs found. The screen is divided into multiple sections and is discussed below. The red status
line at the bottom of the RXT WCT will always show the current operational status.
Figure 12 RXT-300 Wireless Network Screen
3.5.1 My Network
The My Network section shows the current Network ID and RF Channel for the RXT WCT. Consequently, the
WCT can only search and re-configure RXTs with the same channel and network ID and will perform
operations on this screen based on this wireless network. RXTs will only communicate with one another if
they are set to the SAME Channel and Network ID. Entering a new value in either of these fields will cause
the RXT WCT radio to reboot and update to the new setting.
Channel Sets RF Channel on WCT radio. (Range of values: 0 – 15)
Network ID Sets Network ID on WCT radio. (Range of values: 0 – 65534)
Figure 13 My Network Section