Instruction manual

RXT Wireless Configuration Tool
RXT WCT Instruction Manual Rev 0.0 Page 10 of 33
3.4 View/Edit Configuration File (RXT-300 Only)
The View/Edit Configuration File screen is available only for the RXT-300 configuration tool and can be
selected from its main configuration tool screen. It is used for viewing and editing a configuration file that has
been previously saved. To open a file, the user must first select the appropriate file from the available list and
then select “Open”. Only one file may be selected at a time. The user will then be able to view and make any
changes to the configuration just like the Create Configuration File screen (See section
3.3).
Figure 11 View/Edit Configuration File Screen
3.5 Wireless Network
The Wireless Network screen is selected from the main configuration tool screen and is used for finding and
loading configuration files to RXTs on the wireless network. There are three main sections on this screen: My
Network, Operations and RXTs in My Network. At the bottom of the screen there is a single status line of any
ongoing operations.
When entering this screen, the RXT WCT will connect to the USB SNAP Stick and locate itself on the channel
and network ID of the SNAP Stick. The current channel and network ID of the WCT is shown in the My
Network section of the screen. The WCT will show a red status line giving the progress as it goes through the
initialization. The following actions will take place:
• Initialize connection to USB SNAP Stick.
• Initialize the RXT WCT to Network ID and Channel shown in My Network.
• Search for other RXT WCTs on that wireless network and assign an address to itself that does not
conflict.
• Starts Search My Network for RXTs in My Network. Results are listed in RXTs in My Network.