User guide

ManualsBrandsDetcon ManualsHardwareRemote Cal / Remote Sensor Separation Kit

INSTALLATION INSTRUCTION

Detcon Remote Cal /

Remote Sensor Separation Kit

Tubing for Cal

Gas

Remote

condulet with

sensor

Sensor

Transmitter

wiring to Control

Monitor

Applies to all Remote Separation Kits

DETCON, Inc.

3200 Research Forest Dr.,

The Woodlands, Texas 77387

Ph.281.367.4100 / Fax 281.298.2868

www.detcon.com

February 18, 2009• Document #2178• Revision 2.1

Summary of content (4 pages)

PAGE 1
INSTALLATION INSTRUCTION Detcon Remote Cal / Remote Sensor Separation Kit Remote condulet with sensor Tubing for Cal Gas wiring to Control Monitor Sensor Transmitter Applies to all Remote Separation Kits DETCON, Inc. 3200 Research Forest Dr., The Woodlands, Texas 77387 Ph.281.367.4100 / Fax 281.298.2868 www.detcon.com February 18, 2009• Document #2178• Revision 2.
PAGE 2
Remote Cal Kit Page intentionally blank Shipping Address: 3200 A-1 Research Forest Dr., The Woodlands Texas 77381 Mailing Address: P.O. Box 8067, The Woodlands Texas 77387-8067 Phone: 888.367.4286, 281.367.4100 • Fax: 281.292.2860 • www.detcon.com • sales@detcon.com Remote Cal Kit Remote_Cal_Kit_R21.
PAGE 3
Remote Cal Kit 1. Remove the sensor from the Transmitter Assembly and install the sensor on the Remote Condulet. 2. Install and wire the Sensor to the Terminal Board in the Remote Condulet as described in Figure 3. 3. Locate the most appropriate place(s), and Mount the Remote Condulet with Sensor and Transmitter Assembly as shown in Figure 1. 4. Route the wiring from the Remote Condulet Terminal Board to the Sensor Transmitter Assembly.
PAGE 4
Remote Cal Kit 6. Connect ¼” Teflon sample tubing to the calibration port on the splashguard (Figure 2). Push the tubing onto the calibration port until it seats completely. 7. TP & FP series sensors only: Reference the “Remote Mount Applications” section of the sensor instruction manual for details on setting sensor heater/bridge voltages at the remote sensor location. Set the heater/bridge voltage appropriately. 8. Calibrate the sensor to insure proper operation.