User guide

ManualsBrandsDetcon ManualsEquipment1010-N1 Rack

Detcon Model 1010-N1 Rack Panel Mount Control Enclosure PG.1

Detcon Model 1010-N1 Rack

Panel Mount Control Enclosure

Operator’s Installation & Instruction Manual

July 15, 2004 • Document #2655 • Version 1.1

Table of Contents

1.0 Introduction

1.1 Description

1.2 Specifications

1.3 Remote Reset

1.4 Installation

1.5 Start-Up

1.6 Maintenance and Repair

1.7 Spare Parts

1.8 Warranty

detcon inc.

Summary of content (5 pages)

PAGE 1
detcon inc. Detcon Model 1010-N1 Rack Panel Mount Control Enclosure Operator’s Installation & Instruction Manual July 15, 2004 • Document #2655 • Version 1.1 Table of Contents 1.0 Introduction 1.1 Description 1.2 Specifications 1.3 Remote Reset 1.4 Installation 1.5 Start-Up 1.6 Maintenance and Repair 1.7 Spare Parts 1.8 Warranty Detcon Model 1010-N1 Rack Panel Mount Control Enclosure PG.
PAGE 2
1.0 INTRODUCTION Detcon Model 1010-N1 Rack consists of 3 major assemblies: 1. The NEMA 1 rack mount control enclosure. 2. The single channel digital control modules. 3. The remote mount gas sensor assemblies. The NEMA 1 control enclosure is detailed in section 1.0 of the manual, the control modules in section 2.0, and applicable sensor assemblies in section 3.0. 1.
PAGE 3
1.3 REMOTE RESET The reset function is effective when the Model 10B's respective alarms have been programmed in the latching position and alarm conditions have passed. The alarm reset function is common to all controllers and is activated by closing the circuit between the two reset contacts. A normally open momentary switch is suitable. 1.4 INSTALLATION 1. Securely mount the 1010-N1 rack enclosure in accordance with Figure 1. Fig. 1 5.25 .375 Panel cutout (centered) 17.75" x 5" Panel depth - 8" 2.
PAGE 4
2. Connect 117VAC input to the terminal strip labeled “VAC IN” (L1, N, GND). 3. If applicable, connect a 24VDC source or standby battery to the terminal strip labeled “VDC IN” (+ and –). 4. If applicable, connect a normally open momentary remote mounted switch to the lugless terminal strip (labeled RESET) located on the controller mother board. 5. If applicable, terminate the discrete 4-20 mA output to external device(s). Terminals are labeled “(+) 420” and “(–) 4-20”. 6.
PAGE 5
Fig. 3 This side toward front of power supply assembly Power Supply DC Out 16ga x 9" BLK 16ga x 9" RED + + + +S –S – – – Power Supply GND N L 1 6 Power Supply P1 VAC In 16ga x 6" GND - GRN N - WHT L1 - BLK 1 16ga x 6" 2 16ga x 6" 3 P2 Power Switch BLK 16ga x 6" BLK 16ga x 6" TAN 22ga x 6" TAN 22ga x 6" RED 16ga x 6" RED 16ga x 6" D1 6A 50V P5 P3 Fuse L1 In N In GND In +DC In –DC In +DC Out –DC Out D2 6A 50V BLK 16ga x 3" BLK 16ga x 3" P4 1.