Instruction manual

Treadbelt Adjustment:
Your treadmill's running belt has been properly aligned at the factory.
However, when the treadmill is used on an uneven surface, please follow
these instructions:
1 Stand beside the treadmill, place the Magnetic Safety Clip onto the display
console & follow operating instructions for running the treadmill at 2 mph.
2 If the belt is off-center to the right, turn the left roller adjustment bolt
counter clock-wise
1
⁄
4
turn. If the belt is off-center to the left, turn the left
roller adjustment bolt
1
⁄
4
turn clockwise.
3 Let the machine run for several minutes to check the alignment.
(Belt alignment does not need to be perfect). If more correction is needed,
turn the adjustment bolt
1
⁄
4
turn and check again.
Treadbelt Tension:
Turn both rear roller adjustment bolts counter-clockwise until Treadbelt just begins
slipping when walking on it, then turn both rear roller adjustment bolts clockwise
in equal quarter turn increments until the Treadbelt stops slipping.
Note: Be sure to walk on Treadbelt to ensure that the Treadbelt does not
slip while under load.
Treadmill Calibration:
1 Hold down ENTER and STOP while applying magnetic safety clip
to magnet on keypad. Unit will say CALIBRATION.
2 Press START. Machine will speed up, say WAIT and then say SUCCESSFUL.
3 Remove Magnetic Safety Clip and reapply then use as normal.
W A L K S T A T I O N U S E R I N S T R U C T I O N S 11