Replacement Part List

OPERATION – BEFORE TURNING KEY AND PULL STARTING ENGINE
CLEAR AREA OF ALL PEOPLE AND PROPERTY THAT COULD BE DAMAGED. THINK
SAFETY. STONES FROM THE SOIL CAN BE PROJECTILES AND CAN CAUSE INJURY.
WEAR SAFETY GLASSES, HEARING PROTECTION, AND GLOVES
DO NOT WEAR LOOSE FITTING CLOTHES THAT COULD GET STUCK IN THE MACHINE
MOVING PARTS, ONLY TRENCH SOIL AND SAND, CHILDREN SHOULD NOT RUN THIS
EQUIPMENT, STAY ALERT OF YOUR SURROUNDING AND PERSONS THAT COULD
APEAR IN THE DIGGER PATH WHILE YOU ARE WORKING.
NEVER APPROACH AUGER OR CHAIN WHILE RUNNING – TURN TRENCHER OFF.
BEFORE YOU DIG HAVE THE AREA VERIFIED FOR ANY UTILITIES IN
THE GROUND. BURIED ELECTRICAL LINES, GAS LINES, ETC.
Tip the unit back, lower the cutting chain to the desired depth, there are 5 levels set
by the hand lever on the handle grip.
Make sure the forward brake is lowered into the wheel brake gears. Loosen the
center bolt in the brake bar to set the FORWARD brake system before digging. This
will hold your trencher from moving forward while digging. The unit will roll free in
reverse pull.
Tighten the bolt to release the dual wheel brakes so your unit will roll freely for
transportation.
PERFORMANCE OPERATION -
Your trencher has quick change teeth. The digger points snap out by tapping with a
hammer and replacements snap back into the socket. Use a block of wood when
replacing the teeth. Never strike the cutting tips with a hammer.
Lock your machine and remove the keys when not in use to protect the machine
from unauthorized use.
ALL PARTS ARE AVALIABLE FROM DK2POWER AT 702-331-5353