Instructions / Assembly

STEP 11:
1. Install the work table
2. Use the 8 flat bolts and hardware provided
3. Tighten the 2 bolts on the underside table supports that
were left loose in previous assembly steps.
4. Recheck all assembly bolts and equipment bolts and tighten
if required.
CONGRATS – YOUR ALMOST DONE
Grease the rack teeth and the spline with
standard grease. Keep the log beam free of
grease and keep clean when splitting. The ram
slides on a teflon plate, so keep it clean from
grease and wood particles.
Use 8 bolts provided
REV 1 – 9-19-2019