Instructions / Assembly

OPERATION – BEFORE TURNING KEY AND PULL STARTING ENGINE
CLEAR AREA OF ALL PEOPLE AND PROPERTY THAT COULD BE DAMAGED. THINK
SAFETY. CHIPS ARE FLYING PROJECTILES AND CAN CAUSE INJURY.
WEAR SAFETY GLASSES, HEARING PROTECTION, AND GLOVES
DO NOT WEAR LOOSE FITTING CLOTHES THAT COULD GET STUCK IN THE MACHINE
MOVING PARTS, ONLY CHIP WOOD, CHILDREN SHOULD NOT RUN THIS EQUIPMENT,
STAY ALERT OF YOUR SURROUNDING AND PERSONS THAT COULD APEAR IN THE
CHIP PATH WHILE YOU ARE WORKING.
UNIT IS A DIRECT DUAL BELT DRIVE. NO CLUTCH TO SLIP OR BURN UP
BUT YOUR BELTS WILL NEED TIGHTENED AND CHECKED ON A REGULAR BASIS TO
MAINTAIN 100% CUTTING POWER.
• Tip the Stump Grinder up with the cutters off the ground when pull starting.
12 CARBIDE CUTTERS 14 IN DIAMETER WHEEL FOR COMMERCIAL PERFORMANCE
SET THE BRAKE TO PIVOT ON WHEEL WHILE GRINDING. APPROACH STUMP FROM
THE TOP, CUTTING STRAIGHT DOWN INTO THE STUMP WITH THE 3.5 INCH WIDE
CUTTING TEETH. RAISE UP OUT OF THE CUT, MOVE OVER, PLUNGE AGAIN. REPEAT
ACROSS ENTIRE STUMP. MOVE SIDE TO SIDE TO FACE OFF THE STUMP. ADJUST
YOUR BOW HANDLE FOR COMFORT.
TIGHTEN ALL BOLTS AND TEETH BEFORE EACH USE. TEETH ARE NOT COVERED
UNDER WARRANTY. CLEAN ALL STONES AND ROCKS AWAYS FROM CUTTING STUMP
AREA, CHECK FOR METAL STAKES AND OR NAILS IN THE TREE STUMP BEFORE
CUTTING.
KOHLER ENGINES HAVE A LOW OIL SHUTOFF TO PROTECT THE ENGINE, TILTING THE
GRINDER MORE THAN 29 DEGREES ANGLE CAN CAUSE THE OIL TO ROLL BACK AND
THE LOW OIL SENSOR WILL SHUT THE ENGINE OFF. CUT YOUR STUMP 9 TO 10
INCHES OFF THE GROUND SO YOU DON’T TRIP THE SENSOR ON THE ENGINE.
READ AND OBEY ALL WARNING LABELS ON THIS MACHINE.
REMOVE THE UNIVERSAL TOW BAR WITH TROLLEY WHEEL WHEN GRINDING.