Use and Care Manual

PartIII:OperatingtheWoodChipper

10

7. IftheWoodChipperhasnot beenrunning(coldengine),warm uptheenginebyrunning
theengineathalfthrottlefor3to4minutes,thenadvancetheenginethrottlecontrolto
themaximumspeed.
8. Adjustfeedingfunctionhandleto“Forward”position.
9. Adjustthefeedrollerto
properspeed.Slowforlargetreesfastforsmalltrees.

Stopping

1. Adjustfeedspeedbarto“0”position.
2. Adjustfeedfunctionhandleto“STOP”orneutralposition.
3. MovetheThrottleLevertoIDLE.
4. RecoilStart:TurntheIgnitionSwitchtotheOFFposition.
5. ElectricStart:TurntheKeytotheOFFposition.

OperatorZone

WoodChipping
NOTICE
Woods’andbranches’diametershouldbenobiggerthan5inches.


WARNING
Donotplaceyourhandsintothechutewhenloading.ThisisaveryUNSAFEmethodandcould
resultininjurytoyourhands.
Donotreach or stepacross therailwhiletheWoodChipperisrunning.ThisisaveryUNSAFE
methodwhichcouldcausepersonalinjury,evendeath.
