CHIPPER ASSEMBLY GUIDE MODEL: OPC503 3 INCH CHIPPER SHREDDER TOP LOAD DETAIL K2 INC. DK2 POWER USA 4301 S Valley View Blvd STE 10-11 Las Vegas, NV 89103 1-702-331-5353 DETAIL K2, INC. 1080 Clay Avenue Unit 2 Burlington, Ontario, Canada L7L0A1 DK2 USA EAST 6245 Industrial Parkway Whitehouse, OH 43571 PARTS AND SERVICE 702-331-5353 OR WWW.DK2POWER.
STEP 1: 1. Install the axle with bolts provided.
STEP 2 1. Install wheels. Use locking pins in axle to lock wheels from moving while your chipping, or free wheel when towing.
STEP 3: 1. Install drop stand 2.
STEP 4: 1. Install the 3 inch tree feed chute with the bolts provided.
STEP 5: 1. Install handle with 4 bolts.
STEP 6: 1. Mount the top chute to the unit. 2.
STEP 7: 1.
STEP 8: 1. 2. 3. 4.
STEP 9: READ THE ENGINE MANUAL SUPPLIED WITH YOUR UNIT FOR FULL ENGINE OPERATION, SAFETY, AND MAINTENANCE. 2 1 3 7 4 6 5 1 ON/OFF KEY LOCK 2 GAS – USE MID GRADE OR HIGHER 3 CHOKE – LEFT IS ON / RIGHT IS OFF (RUN POSITION) 4 GAS ON/OFF SWITCH – LEFT IS OFF / RIGHT IS ON 5 THROTTLE – RABBIT FAST / TURTLE SLOW 6 PULL STARTER – PULL TIGHT- THEN PULL START 7 OIL – FILL TO MARK 10W30, WILL NOT START IF OIL IS LOW, HAS LOW OIL SHUTOFF PROTECTION. 2 YELLOW CAPS ARE OIL FILL CAPS.
Ref.No. Description Ref.No.
OPERATION – BEFORE TURNING KEY AND PULL STARTING ENGINE CLEAR AREA OF ALL PEOPLE AND PROPERTY THAT COULD BE DAMAGED. THINK SAFETY. CHIPS ARE FLYING PROJECTILES AND CAN CAUSE INJURY. WEAR SAFETY GLASSES, HEARING PROTECTION, AND GLOVES DO NOT WEAR LOOSE FITTING CLOTHES THAT COULD GET STUCK IN THE MACHINE MOVING PARTS, ONLY CHIP WOOD, CHILDREN SHOULD NOT RUN THIS EQUIPMENT, STAY ALERT OF YOUR SURROUNDING AND PERSONS THAT COULD APEAR IN THE CHIP PATH WHILE YOU ARE WORKING. UNIT IS DIRECT DRIVE.
QUICK START AND TROUBLE SHOOTING GUIDE QUICK START SETUP • • • • • • • ADD 10W30 OIL TO ENGINE ADD GAS PIN BOTH WHEELS INTO PIVOT BRAKE HOLES. TURN KEY ON HALF THROTTLE (CHOKE OPTIONAL FOR COLD STARTS) SET THROTTLE TO JUST OVER TURTLE PULL START THE ENGINE TREE CHIPPING • • • • ENGINE ON HIGHEST SPEED FEED SMALLER TREES INTO CHUTE AND LET GO, TREE WILL AUTO FEED. FEED LARGER TREES SLOWLY ALLOW CUTTER WHEEL TO REGAIN RPM SPEED BETWEEN CUTS. FEED LEAVES, TWIGS AND UPTO 3/8 INCH DIA TREES INTO TOP HOPPER.
PLEASE DO NOT RETURN TO THE STORE YOU HAVE A 1 YEAR WARRANTY AND DK2 WILL REPLACE A DEFECTIVE PART FOR FREE CALL US AT 702-331-5353 FOR FAST WARRANTY PARTS AND QUESTIONS WHAT IS COVERED – 3YR ENGINE AND 1 YEAR COMMERCIAL WARRANTY INCLUDED Detail K2 Inc. warrants to the original purchaser that model OPC503 will be free and clear of manufacturing defects in workmanship and materials under normal use and service for a period of one (1) year from the date of the original purchase.
