Replacement Part List

En.8 DK2 Everest R-3 man.
ENGLISH
Pre-Installa�on
The Installaon should be completed on an asphalt/concrete surface, with suient area to work. Un-
package your new FRISTTRAX Snowplow, discard all shipping materials, recycle if possible. Once the plow is
un-packaged, slowly roll the plow from its upright shipping conguon over onto the built-in cart. Top up
the oil reservoir to ine indicated with the 1L of hydraulic oil provided. Your new FIRSTTRAX Snowplow
is now ready to be installed.
Installa�on
Step 1 – Install moun�ng brackets and cross bar.
Please follow the instrucons included in your mount kit. Fit in place with all fasteners (nger ght) then
proceed to ghten with appropriate tools.
Step 2 – Install the main power cord.
**ALWAYS EXERCISE CAUTION WHEN USING HAND TOOLS AROUND THE BATTERY! A SOLID
CONDUCTER SUCH AS A METAL WRENCH CAN CAUSE SEVERE INJURY, FIRE, OR EVEN CAUSE THE
BATTERY TO EXPLODE!
Aach the short lead on the breaker to the posive “+” terminal of the baery. Secure the breaker to the
fender orewall with the use of screws or zip es in a place where it will not come into contact with the
ne terminal. Aach the negave lead to the negve “-“baery terminal. Route the wires from the
baery in the best possible way to
the front of the vehicle avoiding areas that can become hot or cause
frion when the vehicle is in use. Zip e the wires to the vehicle’s structure so that they do not move or
shi when in operaon. Conrm the breaker is in the closed posion, and then close the hood slowly to
make sure yet again that the wires are clear from pinch points.
INSTALLATION STEPS