Installation Guide

v.170626 En.9

ENGLISH

I.D. Name Function

I Blade angle locking handle operates blade angle locking pin to allow blade to move between 22 and 38

degrees right or left, or straight across

J Winch raises and lowers the blade

K Main frame Holds the winch and connects to the a-frame and your custom mount

L Lift strap connects the winch to the blade

M Safety chain holds the blade in raised position for transport

N Wiring harness carries power for winch

P D frame carries the blade and holds its angle to direction of travel

Q Back support carries the weight of the plow during mounting, dismounting, and storage

R A frame main frame mounting plow to vehicle

S Winch control switch with lead operates the winch and therefore the plow, up and down from within the vehicle

T Winch control box supplies power to the winch as commanded by the winch control button

U Circuit breaker protects winch and vehicle electrical system

V T Frame Cross Member inserted into the 2” front mount receiver

W Wireless Remote Conversion Kit order as WR100

X Blade Support Arms added strength by improving your mounting connection from one point to three

FUNCTIONAL DESCRIPTION

SNOWPLOW ASSEMBLY

1. Carefully unpack the carton (g.2), accounting for each of the parts by referring

to the function picture, parts list and schematic drawing (see page En.21)

2. Continue to refer to the parts list and exploded drawing while assembling the

plow.

3. Using the grade 8 bolts and nuts included, bolt together the two halves of the

snowplow blade (g.3, C

and C

, below).

4. Attach the scraper (three pieces, a long, S

and two short ones, S

; g.4, at left)

to the front lower edge of the full blade using 25 mm (1”) x M10 grade 8 carriage

bolts, 10 mm washers, and M10 Nylock nuts (g.5). The long piece of the

scraper overlaps both halves of the blade. The

shorter piece lls in the rest. The carriage bolts are

inserted so that their domed caps are at the front of

scraper, which lies on the lower front (concave side)

edge of the blade. The nuts screw on from the back

(convex) side of the plow blade. Tighten the nuts.

nowp

(

g

)