Manual

E-2 95-86762.1
ECLIPSE CO
2
HART MENU STRUCTURE
This section displays the menu trees for the Pointwatch Eclipse CO
2
model. The menu tree shows the primary commands and options available when using
menu selections.
Eclipse_CO2
Device Variables
Diagnostics
Device setup
Device Variables
Process Variables
Identification
Diagnostics
Status/Fault Menu Test device Calibration
History
Device Setup
Basic Setup Detailed Setup Output condition
Review
Identification
Device Info
HART Info
Process Variables
Gas PV Loop Current
PV % rnge Range Values PV *
* Available with Graphic Option only
** Viewable in User Defined Fault Mode only
Range Values
PV USL PV LSL PV URV PV LRV
Device Info
Manufacture Dev id Model Revision #’s
HART Info
Tag Long tag Message Date Write protect Final asmbly num
Status/Fault Menu
Fault 1 Fault 2 Status 1 Status 2 Operating mode
Calibration mode
Basic Setup
Gas PV Snsr unit PV URV Device information
Detailed Setup
Gas Type Sensor information
Write protect
Output Condition
Config Gas Alarms
Config fault out
HART output Com Port
Review
Model
Manufacturer Tag Date Descriptor
Message Gas Type Gas PV Snsr unit PV USL High Alarm Level
High Alarm Latch
Low Alarm Level
Low Alarm Latch
Cal Conc
Analog fault codes
Spcl Gas Vol% Spcl Gas coef A Spcl Gas coef B Spcl Gas coef C Spcl Gas coef D Spcl Gas coef E Protocol Poll adrr
Baud Rate Parity Final asmbly num
Alrm type Write protect Dev id Universal rev
Fld dev rev Software rev Poll addr
Num req preams
Test device
Loop test
Self test Response test
Reset
Calibration
Zero trim Calibrate Sensor
Snsr temp D/A trim
History
Running hrs Max temperatures
Min temperatures Calibration log
Event log
Calibrate Sensor
Calibrate
Cal Conc Gas Type CalDate
Device information
Manufacturer
Dev id Tag Long tag
Date Descriptor Message Model Write protect Final asmbly num
Sensor information
PV USL Active Reference
Ratio Absorption
Span Factor Snsr temp Vol% @ 100% FS
Write protect
Password Set Write protect Write protect
Config Gas Alarms
High Alarm Level
High Alarm Latch
Low Alarm Level
Low Alarm Latch
Config fault out
Analog fault codes Analog fault values **
HART output
Poll addr Num req preams
Com port
Protocol Polling addr
Baud Rate Parity
Revision #’s
Universal rev Fld dev rev Software rev Hardware rev
NOTE
Refer to “Alarm Relays” in the Specifications section of this manual for important information regarding alarm relays.