Instructions / Assembly

3
Combustible material should not be within 72 inches of the top of the unit, or within 48 inches around
the entire unit.
Keep the appliance area clear and free from combustible material, gasoline and other flammable vapors
and liquids.
If the flame goes out while burning, turn the gas valve off. Wait 5 minutes before repeating the initial
lighting procedure. Once you have a flame started, hold down
the control knob for 1 minute.
Do not add water into the unit.
Do not operate unit if any part has been under water. Immediately call a qualified service technician to
inspect the appliance and replace any part of the control system and any gas control that has been under
water.
Do not disconnect any part while unit is in use.
Do not store a spare propane tank on or near this unit.
If the heating unit is indoors, detach the propane tank and leave outdoors.
Do not operate on a boat or vehicle. This unit must be used on a flat surface and outdoors ONLY
Always remove protective cover before operating (if applicable).
Do not set the protective cover over the unit until it is turned off and completely cooled down.
Check for leaks after not using the unit for long period of time.
Children should never operate this unit. Children must be supervised while near this unit.
Keep gas tank at least 5 feet away from unit when lit. (if external tank)
The maximum gas supply pressure is 250psi.
All installation and repair should be done by a qualified professional. This unit should be inspected
annually and cleaned regularly.
Inspect all elements of this heating unit before each use. If there is damage, the burner must be replaced.
Keep the hose out from any pathways to eliminate any accidental damage. (if external tank)
Be aware of the hazards of high temperatures and stay away from the unit to avoid any burns or injury.
The gas supply tank should be constructed and marked with the specifications for the LP gas tanks of
the U.S. Department of Transportation or the National Standard of Canada C
AN/CSA-B339, LP gas
tanks, spheres and tubes for Transportation of Dangerous Goods; and Commission.
The LP gas tank must have a listed overfilling prevention device and a QCCI or Type I, (CGA810) LP
gas tank connection.
This heating appliance should not be used on plastic or artificial wood decks.
Children and adults should be alerted to the hazards of high surface temperatures and should
stay away t
o avoid burns or clothing ignition.
Young children should be carefully supervised when they are in the area of the appliance.
Clothing or other flammable materials should not be hung from the appliance or placed on or
near the appliance.
Any guard or other protective device removed for servicing the appliance shall be replaced
prior to operating the appliance.
Installation and repair should be done by a qualified service person. The appliance should be
inspected before use and at least annually by a qualified service person. More frequent
cleaning may be required as necessary. It is imperative that the control compartment, burners
and circulating airways of the appliance are kept clean.
IF APPLICABLE:
Allow heating item to cool completely before placing on lid.
DO NOT use heating item while lid is installed. Always remove the lid while heating item in use.