Specifications

Clear EML and LTM: The Event Memory Log and Long Term memory can be cleared by entering 9898

while in program mode.

Clear Keypad Status: Under very unusual circumstances, a keypad may not receive a transmission from

the control panel resulting in a status message not being cleared. This command

clears all status messages at the keypad.

Clear User Codes: This location will erase user codes 2 through 8.

Delay Before Dial: For both phone numbers, the system will wait a programmed time period (1 to 255

seconds) after activation before dialing the central station. If a value of 000 is

programmed, the communicator is disabled. If an alarm activation occurs and the

system is disarmed before the delay expires, the system will not communicate to the

central station. Valid delay values are 1-255 seconds.

Dial Alternate Number: If only one phone number is selected and the system is unable to communicate, the

system will try to contact the second number.

Dial Attempts: This option controls the maximum number of times the communicator will attempt to

call the central station. If the communicator is unable to connect with a central

station, the system will either stop dialing or begin dialing an alternate phone

number. The system can be programmed to show communicator trouble at the

keypad if all dialing attempts are unsuccessful. A communicator trouble condition

will automatically clear from the keypad the next time the system is armed.

Dial Phone Number 1: This option tells the control panel to always call phone number #1 if the

corresponding zone type is the cause of an activation.

Dial Phone Number 2: This option tells the control panel to always call phone number #2 if the

corresponding zone type is the cause of an activation.

Dialer Option: Each zone is individually programmed to report to the central station as well as each

zone type. If a zone is programmed to report to the central station and the zone type

is disabled or only programmed to report to the event memory log, the zone will

NOT be reported to the central station.

Direct Connect: Used with the PC software. Connect the modem to the panel's R and T terminals.

Activate the direct connect option in the PC software and with the control panel in

program mode, enter 9952.

Disable Force Arming: When this option is programmed, the system will not arm if zones are open unless

the system is armed from an Arm/Disarm zone input. This option must be enabled in

a UL installation.

Disappearing Activations: User codes 2-8 can be programmed as disappearing codes. A disappearing code

remains active for the number of times programmed in location 0129. When a code

becomes inactive, a user can reset the disappearing counter by changing the disarm

code.

Disarm Before Rearm: With this option selected, the system can only be armed from AWAY to HOME after

disarming and vice versa. This prevents an intruder from turning off interior

protection if they are able to circumvent perimeter protection.