Specifications

Bypass Mode: To bypass individual zones, enter a valid full function code followed by the 9 digit.

The system will speak "BYPASSED MODE, ENTER ZONE NUMBER." Press a two-digit

zone number (leading zero if necessary). The current bypass state of the zone is

spoken. Pressing A toggles the bypass status (confirmed in speech). Pressing H exits

bypass mode. To unbypass all bypassed zones, enter 00 as the two-digit zone

number.

The following are system operation notes relative to bypass:

1) Bypassed zones will display open/close if programmed to do so.

2) Bypassed zones that show as open are ignored for purposes of forced arming.

3) No monitor speech or beep or alarm activation will occur for a bypassed zone.

4) Only zones that exist in the system can be bypassed. The system will issue 3-

beeps if an invalid zone number is entered.

5) Fire zones and disabled zones cannot be bypassed.

6) As a programmable option, any bypassed zone will automatically unbypass the

next time the system is disarmed. If this option is not programmed, bypassed

zones will remain bypassed until they are manually unbypassed.

Bypassing is not permitted in a UL installation.

Callback Wait Duration: The amount of time the panel will wait after a digital communication for the central

station to call during a two-way callback session.

Central Station Account: Each phone number has an account number associated with it. You may use a 3- or

4-digit account number. If Ademco Contact I.D. is being used as the reporting

format, a 4 digit account number must be used. The system allows additional

characters as follows:

Hexadecimal Digit # or H Followed By

F 5

Central Station Handshake: This location determines the amount of time the communicator will wait for a central

station receiver digital handshake.

Central Station Number: Space is provided for two 16-digit phone numbers. These numbers are programmed

as normally dialed. To enter communicator phone numbers, enter the appropriate

9000 location and enter the number. The system places the numbers in the

appropriate locations. There are characters that are available in the dialing string

that are not found on the keypad. The chart below explains how to enter additional

functions:

Dialing Feature # or H Followed By

Dial * 1

Dial # 2

Wait for second dial tone 3

3 second pause in dialing sequence 4

After the number is entered, press # or H key twice to save. Pressing the * or A key

at any time during phone number will clear all digits that have been entered.

Changing User Codes: To change user code, in keypad mode, enter a full function user code (default user 1

is 1,2,3,4), followed by the 7 digit. The system will speak "ENTER USER NUMBER."

Press the 2-digit number (01-08) for the user code you wish to change. You will then

hear "ENTER CODE (the number you selected)". The next four digits pressed will be

the new code. After the fourth digit, the system will speak "EXIT".