System information

CHAPTER
Troubleshooting Fiber Distributed Data Interface 5-65
5
Troubleshooting Fiber Distributed
Data Interface
The Fiber Distributed Data Interface (FDDI) standard was produced by the ANSI X3T9.5 standards
committee in the mid-1980s. During this period, high-speed engineering workstations were
beginning to tax the capabilities of existing local-area networks (LANs)—primarily Ethernet and
Token Ring. A new LAN was needed that could easily support these workstations and their new
distributed applications. At the same time, network reliability was becoming an increasingly
important issue as system managers began to migrate mission-critical applications from large
computers to networks. FDDI was developed to fill these needs.
After completing the FDDI specification, ANSI submitted FDDI to the International Organization
for Standardization (ISO). ISO has created an international version of FDDI that is completely
compatible with the ANSI standard version.
Although FDDI implementations are not as common as Ethernet or Token Ring, FDDI has gained a
substantial following that continues to increase as the cost of FDDI interfaces diminishes. FDDI is
frequently used as a backbone technology as well as a means to connect high-speed computers in a
local area.
FDDI Technology Basics
FDDI specifies a 100-Mbps, token-passing, dual-ring LAN using a fiber-optic transmission medium.
It defines the physical layer and media-access portion of the link layer, and is roughly analogous to
IEEE 802.3 and IEEE 802.5 in its relationship to the Open System Interconnection (OSI) reference
model.
Although it operates at faster speeds, FDDI is similar in many ways to Token Ring. The two types
of networks share many features, including topology (ring), media-access technique (token passing),
and reliability features (redundant rings, for example). For more information on Token Ring and
related technologies, refer to Chapter 6, “Troubleshooting Token Ring.”
One of the most important characteristics of FDDI is its use of optical fiber as a transmission
medium. Optical fiber offers several advantages over traditional copper wiring, including security
(fiber does not emit electrical signals that can be tapped), reliability (fiber is immune to electrical
interference), and speed (optical fiber has much higher throughput potential than copper cable).
FDDI defines use of two types of fiber: single mode (sometimes called monomode) and multimode.
Modes can be thought of as bundles of light rays entering the fiber at a particular angle.
Single-mode fiber allows only one mode of light to propagate through the fiber, whereas multimode
fiber allows multiple modes of light to propagate through the fiber. Because multiple modes of light
propagating through the fiber may travel different distances (depending on the entry angles), causing
them to arrive at the destination at different times (a phenomenon called modal dispersion),
single-mode fiber is capable of higher bandwidth and greater cable run distances than multimode