Manualshelf

User`s manual

ManualsBrandsDestination Audio ManualsComputer equipmentCS500
141142143144145146147148149150
Content Security Gateway User’s Manual
- 145 -
Configure：Click Modify to modify the PPTP Client settings or click Remove to remove the
item.
Adding a PPTP Client
Step 1. Select VPN→PPTP Client.
Step 2. Configure the parameters.
User name: Specify the PPTP client. This should be unique.
Password: Specify the PPTP client password.
Server Address: Enter the PPTP Server’s IP address.
Encryption: Enable or Disabled the Encryption.
Remote Server:
Single Machine: Check to connect to single computer.
Multi-Machine: Check to allow connecting to multiple computers on remote site.
IP Address：Enter the PPTP Client IP address.
Netmask: Enter the PPTP Client subnet mask.
Always-connect: Select to keep on the connection working.
Auto-Connect when sending packet through the link: Check to enable the auto-connection
whenever there’s packet to transmit over the connection.
Auto-Disconnect if idle minutes: Configure this device to disconnect to the PPTP Server
when there is no activity for a predetermined period of time. To keep the line always
connected, set the number to 0.
Schedule：Click the down arrow to select the schedule, which was pre-determined in Schedule.
Refer to the corresponding section for details.