User`s manual

Content Security Gateway User’s Manual
- 142 -
 Disable PPTP：Check to disable PPTP Server.
 Enable PPTP：Check to enable PPTP Server.
Encryption: the default is set to disabled.
Client IP Range: Enter the IP range allocated for PPTP Clients when they connect to
the PPTP server.
 Auto-Disconnect if idle □ minutes: Configure this device to disconnect to the PPTP
Server when there is no activity for a predetermined period of time. To keep the line always
connected, set the number to 0.
 Schedule：Click the down arrow to select the schedule, which was pre-determined in
Schedule. Refer to the corresponding section for details.
Step 4. Click OK to save modifications or click Cancel to cancel modifications
Adding PPTP Server
Step 1. Select VPN→PPTP Server. Click New Entry.
Step 2. Enter appropriate settings in the following window.
 User name: Specify the PPTP client. This should be unique.
 Password: Specify the PPTP client password.
 Remote Client:
 Single Machine: Check to connect to single computer.
 Multi-Machine: Check to allow multiple computers connected to the PPTP server.
IP Address: Enter the PPTP Client IP address.
Netmask: Enter the PPTP Client subnet mask.
 Client IP assigned by:
1. IP Range: check to enable auto-allocating IP for PPTP client to connect.
2. Fixed IP: check and enter a fixed IP for PPTP client to connect.