Specifications

28. Technical Specificatons
IP Office Matrix - Release 8.1 (2)
Page 84
Interface
Information
DTE Port
• IPO 406 V2, IP412 and IP500: 9 way D-type female connector,V.24/V.28
EU Interfaces:
• BRI:
RJ45 sockets. ETSI T-Bus Interface to CTR3 for Pan European Connection.
• PRI E1:
RJ45 socket. ETSI T-Bus Interface to CTR4 for Pan European Connection.
• PRI T1/J1:
RJ45 socket: FCC Part 68/JATE connection.
ISDN Ports
USA Interfaces:
• PRI T1 Service:
Ground Start (GS) – Default, E&M, 56k data for 5ESS, 56/64/64 restricted for 4ESS.
• PRI ISDN Switch support:
4ESS, 5ESS, DMS-100, DMS-250 (includes conformance to ANSI T1.607 and Bellcore Special Report SR4287, 1992).
• PRI ISDN Services:
AT&T Megacom 800, AT&T WATS (4ESS), AT&T SDS Accunet 56kB/s and 64kB/s (4ESS), AT&T Multiquest (4ESS).
Analog Trunk Ports
• RJ45 sockets: Loop start/Ground start (regional dependant)
• RJ45 sockets: Only on ATM16 expansion Module. The first two trunks on the module are automatically switched to
power fail sockets on the rear of the unit in the event of power being interrupted must be loop start for correct power
fail operation.
• IP500 - IP500 Analog Phone 8 Base Card when fitted with an IP500 Analog Trunk daughter card, the combination
supports 1 power failure extension to trunk (loop-start only) connection.
Power Fail ports
Combination Base Card (IP500v2 only)
• IP500v2 Port 8 can also act as a Power Fail port if an ATM4 daughter card is fitted.
ETR6 Base Card (IP500v2 / Essential Edition - PARTNER® Version only)
• IP500v2 Port 7-8 Power Fail Analog Phone Ports*
*The Power Fail Analog Phone ports are wired together and provide one circuit only in the event of power fail if an
ATM4 daughter card is fitted.
ISDN Data Rates
• BRI: B-channel 64kbps or 56kbps, D-channel 16kbps.
• PRI: B-channel 64kbps or 56kbps, D-channel 64kbps.
• RJ45 sockets. EU - Telephone ports act as Master sockets.
• CLI Schemes: DTMFA, DTMFC, DTMFD, FSK and UK20.
Analog Phone Ports
• REN: 2 (External Bell via POT port: REN = 1)
• Off Hook current: 25mA.
• Ring Voltage: 40V (nominal) RMS.