Owner's manual

Troubleshooting Protocol Manager Instruction Manual
44 Version 1
Copyright © 2013 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
2. Click on Window and Setup (Figure 35) to get
to Comm Setup (Figure 36).
3. Click on Network and highlight the desired oven. Click Edit. Make sure addresses on the
Protocol Manager screens match the addresses on each controller (Figure 37). For Protocol
Plus controllers, ensure the password is set to the default (Level 2). Enable Communication
should be enabled. Click Set when complete to save changes (if any).
Figure 35. Window Pull Down Menu.
Figure 36. Comm Setup Typical Settings.