Owner's manual

INSTALLATION & SETUP Protocol Manager Instruction Manual
24 Version 1
Copyright © 2013 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
3.5. Network Summary Window
Click Window and then Network Summary to display the Network Summary Window (Figure
19).
Network Summary Window simultaneously displays parameters for all controllers connected in
the system. Network Summary Window parameters include:
 Controller Name and Address
 Controller Online/Offline Status
 Operating Mode
 Run/Stop/Hold Status
 Temperature Setpoint and Value
 Alarms and Events Status
 Cycle Complete and Buzzer Status
Set the NetSummary parameters by selecting among the check boxes in the Windows Tab
(Section 3.4.4, Figure 17). Double-click on a Controller ID in the Name column to display the
associated Controller Run Time window (Figure 20).
3.6. Controller Run Time Window
The Controller Run Time Window displays the current status of an individual controller. Use this
window to remotely control the controller operating mode and state.
Double-click on a Controller ID in the NetSummary screen Name column (Figure 19) to display
the associated Controller Run Time Window (Figure 20). Controller Run Time Window
parameters include:
 Controller Name and Address
 Temperature Setpoint and Value
 Alarms and Events Status
 Cycle Complete and Buzzer Status
 Operating Mode
 Run/Stop/Hold Status
 Controller Online/Offline Status
 High Limit Setpoint and Value
 Time Remaining in Timer Mode
 Profile, Segment, and Time in Profile Mode
Figure 19. Network Summary Screen.