Owner's manual

INSTALLATION & SETUP Protocol Manager Instruction Manual
16 Version 1
Copyright © 2013 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
After the installation has completed,
click Finish on the InstallShield
Wizard Completed screen (Figure 9).
3.4. Protocol Manager Software Setup
After installing the Protocol Manager software and configuring the controllers, setup the network.
3.4.1. Startup and Login
This procedure uses the Protocol Manager Software installed on a PC.
1. Start Protocol Manager
a. Click Start
b. Click Programs
c. Click Protocol Manager from the list of options

Logging in to Protocol Manager for the first time may signal a
message that no setup information has yet been loaded and that
a password is required. Enter the password “despatch” to
proceed.
2. Login to Protocol Manager
a. Click Login from the pull down menu (or double click on logged out)
Figure 9. Installation Completed Screen.