Owner manual

WORKING WITH OPERATING MODES Protocol 3 Controller Owner’s Manual

44 Version 1.2

means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and

retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.

5.5.2. File Naming Conventions

The Protocol 3 controller names the first recorder log file 000001‐1.csv. Each time the recording

parameters are changed, a new file is created. For instance, changing the recording parameters

two times would produce these file names:

 000002-1.csv

 000003-1.csv

Note that:

 Stopping or starting a recording does not create a new file.

 For any file exceeding 65,500 data lines, the Protocol 3 controller creates a new file with

the last digit incremented by 1, for instance: 000001-2.csv, then 000001-3.csv.



During Data Transfer, normal operation carries on in the

background but operator access to other screens is not

possible.

Transfer of full memory can take up to 12 minutes. Begin a

transfer only when access (e.g. setpoint changes) will not be

required.

5.5.3. Create a New Name Before Writing to the USB Device

Before writing a file (Write Recorder Log File, Write Profile File, Write Configuration File), to

the USB device, create a new name for the file or folder.

1. Insert the memory stick into the USB port.

2. For Enter USB Mode Unlock Code, press to reach 0010.

3. Press to display the Read/Write To USB Device? choices:

a. Write Recorder Log File

b. Read Profile File

c. Write Profile File

d. Read Configuration File

e. Write Configuration File

4. For Write Recorder Log File, press to display Enter a Folder Name.

5. Input unique file name: press to move right and to move left. Press or

navigate through numbers, uppercase letters and lower case letters.

6. For Confirm Write?,

a. Press No to abort the process and return to the previous menu

b. Press Yes to continue to write the file or folder.