Owner manual

WORKING WITH OPERATING MODES Protocol 3 Controller Owner’s Manual
38 Version 1.2
Copyright © 2013 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
b. Press as needed to complete the entry.
17. For Auto-Hold Type, when None is highlighted, press to complete the entry.
18. For Event 1-5, press as needed to accept Inactive.
Program Segment 2 according the Sample Profile:
19. When Segment Number 2 displays, press .
20. Highlight Dwell and press .
21. For Dwell at 100.0°C (212 °F),
a. Press or navigate to 1 hour (01:00:00).
b. Press as needed to complete the entry.
22. For Auto-Hold Type, when None is highlighted, press to complete the entry.
23. For Event 1-5, press as needed to accept Inactive.
Program Segment 3 according the Sample Profile:
24. When Segment Number 3 displays, press .
25. Highlight Ramp Time and press .
26. For Target Setpoint,
a. Press or navigate to 20°C (68°F).
b. Press to complete the entry.
27. For Segment Ramp Time,
a. Press or navigate to 2 hours (02:00:00).
b. Press as needed to complete the entry.
28. For Auto-Hold Type, when None is highlighted, press to complete the entry.
29. For Event 1-5, press as needed to accept Inactive.
Finish Profile Creation:
30. When Segment Number 4 displays, press .
31. Highlight End and press .

Note: Last segment must be an End segment to exit Profile Entry
Mode.