Owner manual

Protocol 3 Controller Owner’s Manual WORKING WITH OPERATING MODES
Version 1.2 37
Copyright © 2013 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
5.3.3. Key In the Sample Profile Setup
To help show the process of setting up a profile, this section uses the sample profile as an
example (from Figure 11 and Figure 12). Figure 10 shows the overall flowchart for working with
Profile Setup. For entering sample values, we choose the default values.
Navigate to and Enter Profile Setup
From Select a Mode screen, simultaneously press and to display the Main Menu:
1. Navigate to and highlight Profile Setup.
2. Press to display Profile Setup Enter Profiler Mode Unlock Code screen.
3. Press to enter Factory Unlock Code 0010.
4. Press to display the Profile Setup screen.
5. Press to select Create a Profile.
6. Press to enter mode.
7. Input unique Profile name: press to move right and to move left. Press or
to navigate through numbers, uppercase letters and lower case letters.
8. After entering the profile name, press as often as necessary to move to the next
screen.
9. For Profile Start Trigger, when None is highlighted, press to complete the entry.
10. For Profile Recovery Method, when Control Off is highlighted, press to
complete the entry.
11. For Profile Abort Action, when Control Off is highlighted, press to complete the
entry.
12. For How Many Time to Cycle Program, press and navigate to the desired
number of cycles.
a. Press to complete the entry.
Program Segment 1 according the Sample Profile (Figure 11 and Figure 12):
13. When Segment Number 1 displays, press .
14. Highlight Ramp Time and press .
15. For Target Setpoint,
a. Press or navigate to 100°C (212°F).
b. Press to complete the entry.
16. For Segment Ramp Time,
a. Press or navigate to 1 hour (01:00:00).