Owner manual

WORKING WITH OPERATING MODES Protocol 3 Controller Owner’s Manual
26 Version 1.2
Copyright © 2013 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
b. Press or to navigate to the desired time or temperature units.
c. Press .
d. Press or to change the SP value.
e. Press .
f. Press to return to normal display.
10. To return to Stopped Mode at any time, press and the Cycle Complete LED will
illuminate.
11. Press to return to Select A Mode screen.
5.2.3. Profile Mode
Navigate to HLSP to set the High Limit Setpoint before running a profile. Use Profile Mode to
select and run profiles that are programmed into the unit (Figure 7). Press or to
navigate, to select the highlighted profile. Press to start profile. Press to stop the
profile and to exit Profile Mode (profile must be stopped to exit Profile Mode).