Owner manual

Protocol 3 Controller Owner’s Manual WORKING WITH OPERATING MODES
Version 1.2 25
Copyright © 2013 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
Hours
Minutes
Seconds
b. After pressing , press to return to Select a Mode screen
7. Adjust the temperature setpoint while running in Manual or Timer Mode by:
a. Press .
b. Press or to select mode of operation.
c. Press .
d. Press or to change the SP value.
e. Press .
f. Press to return to normal display.
8. Return to Stopped Mode at any time, press and the Cycle Complete LED will illuminate
Press to select a mode screen.
5.2.2. Timer Mode
Use Timer Mode to control Time Set Point: when
the time expires, the control output is turned OFF
(Figure 6).
1. Navigate to and highlight Timer Mode.
2. Press or to navigate to the desired
time or temperature units.
3. Press to select the value to change.
4. Press or to change value.
5. Press to enter the desired value.
6. Timer Mode allows you to set event relay status:
a. Press or to navigate to and select
the appropriate relay (Figure 5).
b. Press to toggle the relay ON and OFF.
7. Set all parameters then press or to navigate to and highlight Start.
8. Press to start the process.
a. Press to abort the process
b. Press to return to Select a Mode screen.
9. Adjust the temperature setpoint while running in Manual Mode or Timer Mode by:
a. Press .
Figure 6. Timer Mode Display Screen.