Quick Start Manual

13
Entering Global Parameters For The Profile
Press the mode key until Prof Par is displayed in the Message Display.
Press the SCROLL key and Cycles will be displayed with 1 displayed in the Program display.
Make changes with the UP and Down arrow keys. Press the SCROLL key to move to the next
display.
Note: the segment display must be blank. If not, press RUN/HOLD key until the segment
display is blank.
Description Message Display Setting In Lower Display
Cycle Count Cycles 1
Deviation Hold Dev. Hold OFF
Time Base Pre-x60 ON
Autostart Time Enable Timer OFF
Entering Parameters Common To All Profiles
With Cycles displayed in the Message Display, Press the PROF key until A is displayed in the
Program Display. . Make changes with the UP and Down arrow keys. Press the SCROLL key
to move to the next display.
Description Message Display Setting In Lower Display
Start On Start On Proc
Go To Go To OFF
Delay Time Delay 0.00
Program Lock Lock Prog ON
Power Fail Recovery Period Recovery 0.01
Power Fail Recovery Type Rec Type Cont
Time of Day *
RTC Time Enter time
Day of Week *
RTC Day Enter Day
* Only used if Real Time Clock is installed in the Control.