User guide

64
STEP MODE DISPLAY AVAILABLE
SETTINGS
8 Test Test Enable
Disable
9 Calibration Calib. Enable
Disable
10 Manual control of output (Base Mode) Manual Enable
Disable
11 Setpoint ramp rate (determines whether ramp rate control is
active/enabled or inactive/disabled)
SPRate Enable
Disable
12 Communications Write (writing of parameters via RS485
comm. Link)
ComWrite Enable
Disable
13 Auto Pre-Tune* AutoPT Enable
Disable
14 Units (display units in Base Mode) Units Enable
Disable
15 Password Change PassCh 0 - 9999
*This setting does not determine access. It determines whether the Pre-Tune facility is
automatically activated when power is applied to the instrument.
To return to Base Mode:
1. Press the MODE key until Basemode appears in the message display.
2. Press the SCROLL key to return to Base Mode.