Owner's manual

SECTION 8: ENABLE MODE

To enter the Enable mode, press and hold the SCROLL key. The display flashes for

about 5 seconds, then returns to a normal display for about 5 more seconds, then

displays EnAb. Release the keys, the display should show ESP. Pressing the DOWN

key will display the Enable mode codes in the following sequence:

ESP – ECon – ESEt

Pressing the SCROLL key will display the Enable mode codes with the upper display

blank. The next depression of the SCROLL key will add the Enable code status (ON or

OFF) to the upper display. With the Enable code status displayed, use the UP key to

change the status to ON and the DOWN key to change the status to OFF.

To exit the Enable mode, press the UP key with any Enable mode code displayed in the

lower display and the upper display blank. The control will automatically return to

Control mode if no key is pressed within one minute.

Table 8-1 Enable Mode Parameters

STEP

DESCRIPTION DISPLAY CODE AVAILABLE

SETTINGS

FACTORY

SETTING

1 Setpoint Mode ESP ON/OFF ON

2 Configuration Mode ECon ON/OFF ON

3 Set-Up Mode ESEt ON/OFF ON