Manual

4
Parameter Programming Mode
The control parameters are set through the
Operating and Set-up modes. In most applications, it
is not necessary to alter the oven settings. The
following instructions describe how to access, view
and, if desired, change the parameters.
Once the Operating and Set-up modes are
accessed, the SP LED will start blinking on and off.
The CONTROL will not allow the display to be altered improperly.
The CONTROL will automatically exit the Parameter Programming mode if no keys are
pressed for about two minutes.
Operating Parameters
1. Press key for three (3) seconds.
2. Press the key until the desired
parameter is displayed. See Operating and
Setup Parameter Tables on the following
pages.
3. Press the ▲ or ▼ once to display value.
4. Use the ▲ or ▼ to the desired setting.
5. Press the key to enter the value.
6. Press and hold the key for three (3) seconds to return to the display
mode.
On the next page are the parameter codes, listed in order as they appear.
WARNING: Make sure you
understand what you are
changing before doing so.
Changing the program
parameters will alter the
functions of the CONTROL.
Figure 4. DES2000