CLASSICAL TURNTABLE WITH AM/FM RADIO CD, CASSETTE RECORDER & USB/SD SLOT MODEL: TR-18CD Operating Instructions Manual 1
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO OR SHOCK HAZARD, DO PREVENT NOT BLADE EXPOSURE. TO PREVENT FIRE EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. IMPORTANT SAFETY INSTRUCTIONS 1) Please read these instructions and keep them for future reference. 2) Pay attention to all warnings. 3) Follow all instructions. 4) Do not use this apparatus near water.
Avoid installing this unit in places exposed to direct sunlight or close to heat radiating appliances such as electric heaters, on top of other stereo equipment that radiates too much heat, places lacking ventilation or dusty areas, places subject to constant vibration and/or humid or moist areas. Do not attempt to clean this unit with chemical solvents as this might damage the finish. Use a clean dry cloth.Operate controls and switches as described in the manual.
POWER SOURCE This product is designed to operate on 120V60Hz AC Mains only. Attempting to operate this system from any other power source may cause damage to the system, and such damage is not covered by your warranty. PROTECT YOUR FURNITURE This model is equipped with non-skid rubber 'feet' to prevent the product from moving when you operate the controls. These 'feet' are made from non-migrating rubber material specially formulated to avoid leaving any marks or stains on your furniture.
LOCATION OF CONTROLS AND INDICATORS 1) Dust Cover 10) Function Selector Button 2) Cassette Door 11) CD/USB/SD 3) Speaker Button 4) Cassette Button 12) Disk Tray Door 5) Power Led Indicators 13) CD-Rom Open/close button 6) IR Remote Receiver 14) 3.
BACK PANEL 24) RCA Line out jack 25）FM wire antenna 26）AC power cord REMOTE CONTROL 41) Mute button 42) Program button 43) Repeat button 44) Function Mode button 45) Skip down button 46) Play/Pause button 47) Record button 48) Stop 49) Skip up button button 50) Folder up button 51) Folder down button NOTE: All the buttons on the remote control just use for CD/USB/SD function. OPERATING INSTRUCTIONS Listening to radio 1. Turn the volume knob in a clockwise direction to turn the equipment on. 2.
. AM reception: the receiver has a built-in AM bar antenna. If reception is weak, slightly rotate or reposition the unit to improve AM reception. 8. FM reception: the receiver has a built-in FM wire antenna hanging at the rear cabinet. For best reception, completely unravel and extend this wire. 9. When you have finished listening to the radio, turn the volume knob in a counterclockwise direction to switch the unit off. Unplug it from the power supply if you are not going to use it for a while.
11. At the end of the record, move the lift lever towards the back to raise the tone arm and move it back to the tone arm park, and then move the lift lever towards the front to lower the arm onto its rest. 12. Alternatively, lift the tone arm off the record and return it to the arm rest manually. 13. When you have finished playing records, engage the tone arm lock to protect it from accidental movement. Turn the volume knob in a counterclockwise direction to switch the unit off.
Cassette Operation 1. Cassetter Button Indicators 2. Cassette Button Control a) RECORDER-------Copy RADIO / PHONO /AUX IN / CD / USB / SD to TAPE b) PLAYER--------------Play tape tracks c) REVERSE d) FORWARD e) STOP/EJECT--------1st push – Cassette function stop, 2nd push open cassette door f) PAUSE-----------------Pause when cassette in PlayBack mode. 3.
IMPORTANT! When using the cassette deck : Make sure to insert the cassette in the correct direction. To avoid damaging the cassette, we strongly recommend taking it out of the equipment after playing the cassette. In case erase tape tracks by improper operation, you can choose take off anti-erase tap (write protection) to finalize the recorded-tape. For the same principle, if take off anti-erase tap,this tape would not be able to write new contents/songs.
CD Operation 1. Turn the volume knob clockwise to turn the equipment on. 2. Press the CD-ROM switch, then the disk tray door opens. 3. Place the CD face up inside, making sure it is fully placed .Then press the CD-Rom switch again, the disk tray door closes. 4. To play a different piece on the record, Press the skip up or skip down button to select the desired piece. 5 To adjust the volume level, turn the volume knob to the right or left. CD encoding 1.
(as shown on the label next to the memory card slot), making sure to insert it straight without bending. IMPORTANT: Connecting the USB device upside down or backwards could damage the audio system or storage media (USB drive, SD or MMC card). Check to ensure the direction is correct before connection. 3. Set the function selector to USB/SD mode. (If you have both a USB device and a memory card inserted, press the MODE button to toggle between USB and SD mode.
Important notes The system can detect and read files in MP3 / WMA format only via the USB port or SD card slot. You can connect an MP3 player to the system via the USB socket; however, some MP3 players may not be able to play via the USB socket. This is due to variances in the MP3 encoding format; it is not a malfunction of the system. There are numerous USB and SD device producers and their products vary in solution and format.
Copying a single file/track 1. Insert a USB storage device and SD/MMC card, then select USB/SD mode (as described previously). 2. Press the record REC button during playback of the track you want to copy: “ONE” will be flashing on the display. Press the record REC button again to confirm. 3. The USB or SD icon will be flashing on the display while the system is copying the file. 4. Once the file has been copied, the unit will stop playback automatically.
NOTE: If you press the record REC button during playback in USB or SD mode, the file will copy from USB to SD or vice versa. Deleting files from the USB device / SD card The system is able to erase files stored on the USB drive or SD card. You can delete a single file/track, a folder of files/tracks, or all files/tracks on the storage medium. Deleting a single file/track 1. Insert the USB storage device or SD card, then select USB/SD mode (as described previously). 2.
SKIP UP or SKIP DOWN button to select “ALL” on the display. Press the delete DEL button again to confirm. 3. While the system is deleting the files/tracks, the USB or SD icon will be flashing on the display until the deletion is complete. NOTE: Pressing the delete DEL button will completely delete all files/tracks on the USB device or SD card.
AUX IN encoding 1. Use the function selector to select PHONO/AUX mode and then insert a memory device (USB drive, SD or MMC card). 2. Press the record REC button, it will take 3 - 4 seconds to read the memory device, then the USB or SD icon will be flashing on the LC display. 3. Press the skip up or skip down button to select the desired mode (USB or SD) for encoding, then press the record REC button again to confirm. (You can skip this step if only a USB drive or an SD/MMC card is inserted.) 4.
Troubleshooting Guide If you are experiencing problems with your USB Turntable with Cassette Deck and Radio, check in the section below whether there are any quick and easy checks you can do that may help you solve the problem. If you cannot solve the problem by yourself, contact our after sales support line for advice. Do not attempt to open, repair or modify the equipment yourself. Problems with sound Clockwise rotate the power/volume knob to increase the volume.
Bluetooth input -Receiver Listening to iPhone (or other Bluetooth input devices) 1. Turn the volume knob clockwise to turn the equipment on. 2. Press” PHONO/ AUX/BT IN” on panel for 3 times. ( 1st =Phono , 2nd =AUX , 3rd BT ) or Press mode on remote controller. LCD shows” BT” and flashing. When succeed in connecting, LCD shows “BT” and stable. 3.
FCC Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body Changes or modifica�ons not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
