Installation Instructions

8"
20 cm
18"
45.7 cm
ASSEMBLY
1
Plastic ground sleeve is designed to hold pole vertically
yet release easily. Won’t rust or seize. Attached cap
protects against debris when not in use.
GROUND SLEEVE INSTALLATION
2
Dig hole 8” to 12” in diameter and 16-18” deep. Taper hole
larger at the bottom. Fill bottom of the hole approximately
3” deep with small rocks.
3
Pour about 6” of concrete into the hole, or until it reaches
the bottom of the ground sleeve.
4
Position ground sleeve as shown and pour concrete
around the outside until flush with the top of the ground
sleeve (or 1 - 1½” below top if in a lawn). This will allow
filling top layer with soil and planting.
5
Insert pole into ground sleeve and use a level to align the
pole vertically. Carefully remove pole, without moving the
ground sleeve.
6
Immediately run a small tube or stick down the center
of the sleeve through the concrete until it reaches the
crushed rock base. Remove tube or stick. This will allow
any water to drain.
Honey-Can-Do