Installation Instructions

PART 2

ASSEMBLY

1. Place cross bar F into the notch at the top of the top post G and

align the center hole with the 2 holes at the top of the notch.

2. Place cap E on top of cross bar F and upper post G and align the

holes with the same holes from step 1.

3. Place long eye bolt B through post cap E, upper post G, and

center hole of cross bar F. Secure in place by threading nut C on

the exposed end. Tighten by placing screw driver shaft through the

open end of long eye bolt B and adjustable wrench on nut C.

CB C