Assembly Instructions

Includes:

(1) shelf

(2) brackets

(2) screws

(2) drywall anchors

Suggested Tools:

Bracket Shelf Kit

min.

installation

Make sure that at least one screw will be installed

into wall studs for best results. Use stud finder (not

included) to locate wall studs to hold the

maximum weight.

Locate the wall studs. Place shelf against wall in the desired position. Use a level to

verify that the shelf is level. Draw a horizontal line at each end of shelf on wall with a

pencil. Remove Shelf.

Mark holes for brackets with lines previously marked on wall. Double check holes with

a level and re-mark if neccessary.

For the marks without a wall stud, use a power drill and a 3/16” drill bit. Drill holes into

the wall at the pencil mark. Insert anchor. Install screws into the studs (or anchors).

Make sure they are not flush against the wall.

Note: If you are drilling into a wall where no studs are available, use the proper

anchors to mount the bracket. Anchors have been provided for this purpose.

Align bracket keyholes with screws and then gently pull down on shelf securing it

onto the wall. Remove sticker film from brackets. Place shelf on brackets evenly.

Item#

213-4031

213-4037

Model#

9601051

9601060

3/16”

Size Bracket Shelves

16 in 14 lbs

23 in 17 lbs

MENARDS.COMM4031, 4037 Bracket Shelf Kit E V1