Assembly Instructions

Includes:
(1) shelf
(1) mounting bracket
(6) screws
(4) drywall anchors
(2) set screws
Suggested Tools:
Floating Corner Shelf
min.
installation
15
1
2
3
4
Locate wall stud in corner of wall. Place shelf against wall corner at the desired
height and level the shelf. Verify that the arrow on the bracket is pointing up.
Using a level mark desired holes for screws with a pencil. Remove bracket.
For the holes without the wall stud, use a power drill and a 3/16” drill bit.
Drill holes into the wall at the pencil mark. Insert anchor.
Line the bracket up with the wall stud holes, using a drill, install the screws into the
studs (or anchors) to secure the bracket to the wall.
Note: If you are drilling into a wall where no studs are available, use the proper
anchors to mount the bracket. Anchors have been provided for this purpose.
Additional drywall anchors may be necessary depending on stud placement.
Slide shelf onto bracket. Align holes on bottom of the shelf to holes on bracket tubes,
then drive set screws through holes until shelf is secured to the bracket.
Item#
213-4048
213-4047
Model#
9601043
9601044
3/16”
Size Floating Shelves
12 in 14 lbs
MENARDS.COMM4048 4047 Corner Floating Shelf E V0
Make sure that at least one screw will be installed
into wall studs for best results. Use stud finder (not
included) to locate wall studs to hold the
maximum weight.