Assembly Instructions

Includes:

(1) shelf

(2) pelican brackets

(2) screws

(2) set screws

(2) drywall anchors

Suggested Tools:

Pelican Corner Shelf

min.

installation

Locate wall stud in corner of wall. Place shelf against wall corner at the desired

height and level the shelf. Using a pencil draw a line on either end of the shelf where

you would like to install the pelican brackets. Remove Shelf.

Adjust set screw in bottom of bracket to release top clamp. Place each bracket

against wall in the desired position (previously marked) and mark holes with a pencil

where holes in bracket meet the wall. Use a level to verify that the holes are straight.

For the marks without a wall stud, use a power drill and a 3/32” drill bit. Drill holes into

the wall at the pencil mark. Insert anchor.

Note: If you are drilling into a wall where no studs are available, use the proper

anchors to mount the bracket. Anchors have been provided for this purpose.

Additional drywall anchors may be necessary depending on stud placement.

Place each bracket against the wall aligning the bracket hole with the hole on the

wall. Using a power drill or screwdriver, (for Phillips head screw), drive provided screws

through bracket into studs (or anchors), securing each bracket to wall.

Slide shelf into brackets. Using a screwdriver (for Phillips head screw), tighten set

screws to secure shelf.

Item#

213-4040

Model#

9601035

3/32”

Size Pelican Shelves

12 in 8 lbs

MENARDS.COMM4040 Floating Pelican Corner Shelf E V0

Make sure that at least one screw will be installed

into wall studs for best results. Use stud finder (not

included) to locate wall studs to hold the

maximum weight.